Allan Block USA  |  Photos  |  Vidéos  |  Références  |  Contactez  |  Rechercher un Distributeur 

           

Curves with Geogrid

Document imprimable.pdf

Inside Curves



Geogrid needs to have 100% coverage around an inside curve. To achieve this, additional layers need to be installed either above or below the course where the grid is required to fill voids that are created.
  • Cut geogrid to required lengths per the approved plan.
  • Lay out the primary geogrid around the curve butting front edges together. Make sure strength direction runs perpendicular to wall face. Mark the blocks or take note of the areas where there are voids in the grid placement.
  • Place the filler piece of grid on the next course (or the course below) to cover the void left on the primary layer.
Collection AB
Courbe intérieure avec géogrille

Outside Curves

  • Cut geogrid to required lengths per the approved plans.
  • Lay out the geogrid around the curve.
  • Lift the section of grid that overlaps and place the fill material to separate. Grid layers need to be separated by a 3 in. (75 mm) layer of approved fill material.
  • Never compact directly on the geogrid.

Courbe extérieure
Courbe extérieure avec géogrille

Working with radii
Radius Chart
Building Curves

Twitter Facebook flicker
|  AB International  |  Disclaimer  |

US Patents: #5,484,236, #6,792,731, #6,322742, #6854,236, #7,775,747, #5,623,797, #6,948,282 & #D624,204S
Canada Patents: #2,012,283, #2,133,675, #2,182,321, & #2,432,660
European Patents: #649,714 & #99,308,421.9
Austraila Patents: #682,394, #133,306 & #2003204789 Germany Patents: #69,423,563.6 Japan Patents: #3,142,107
Mexico Patents: #189,846 Taiwan Patents: #NI-72269 International and Other Patents Pending...